Sometimes, it can be useful that the tangents of a Beziere spline have the same length. To perform such a job you can use the equal tangent length tool.

Modes
The equal tangent length tool is available in all modes. Note that it makes most sense to use it in point mode since you can only see the control points and tangents in point mode. This spline tool only works on raw spline objects.

• 
  To use the equal tangent length tool, you first have to select the control points of the spline whose tangents should have the same length. Once you've made your selection call the menu command "ToolsSplineEqual Tangent Length". The tangents of all selected control points will now be repositioned so that both tangents of a control point have the same length. If no selection has been made the command performs on all tangents.

none

Properties

• none